hallo, allso das mit den kunststoff bau wäre einfach zu umfangreich um
es so einfach auf die schnelle zu erklären das fängt beim formbau an und endet beim tempern.
wer trotztem was darüber wiesen wll soll sich am besten das r+g handbuch 06/2009 downloaden hier der link dazu.
http://wiki.r-g.de/index.php?title=Downl...K-Prototyp
gruß
roland
alu drehen
|
|
Nachrichten in diesem Thema |
alu drehen - von roland54 - 16.06.2010, 10:36
RE: alu drehen - von Edwin - 16.06.2010, 11:37
RE: alu drehen - von kieberer0 - 16.06.2010, 12:11
RE: alu drehen - von Booze - 16.06.2010, 17:47
RE: alu drehen - von roland54 - 17.06.2010, 08:33
RE: alu drehen - von Edwin - 17.06.2010, 09:39
RE: alu drehen - von Booze - 17.06.2010, 09:54
RE: alu drehen - von walter - 17.06.2010, 09:57
RE: alu drehen - von roland54 - 17.06.2010, 10:23
RE: alu drehen - von Edwin - 17.06.2010, 10:39
RE: alu drehen - von roland54 - 17.06.2010, 11:03
RE: alu drehen - von Allemool - 17.06.2010, 11:08
RE: alu drehen - von roland54 - 17.06.2010, 12:05
RE: alu drehen - von Schwobaseggl - 17.06.2010, 12:41
RE: alu drehen - von roland54 - 17.06.2010, 12:58
RE: alu drehen - von murxxer - 18.06.2010, 10:11
RE: alu drehen - von roland54 - 18.06.2010, 10:51
RE: alu drehen - von Schwobaseggl - 18.06.2010, 09:16
RE: alu drehen - von roland54 - 18.06.2010, 10:32
RE: alu drehen - von oldradio - 18.06.2010, 09:47
RE: alu drehen - von Gary - 18.06.2010, 16:32
RE: alu drehen - von Booze - 18.06.2010, 19:09
RE: alu drehen - von Bihi - 18.06.2010, 19:22
RE: alu drehen - von Lumpi - 18.06.2010, 23:36
RE: alu drehen - von murxxer - 19.06.2010, 09:29
RE: alu drehen - von roland54 - 19.06.2010, 11:26
RE: alu drehen - von Lumpi - 19.06.2010, 18:21
RE: alu drehen - von Balu - 19.06.2010, 11:59
RE: alu drehen - von roland54 - 19.06.2010, 12:54
RE: alu drehen - von roland54 - 19.06.2010, 18:54
RE: alu drehen - von Basti2290 - 19.06.2010, 21:05
|
Benutzer, die gerade dieses Thema anschauen: 8 Gast/Gäste