Hi Volker!
Denke, dass der Bohrer weicher ist als das Material und an den 'Reibungsstellen' ausglüht. Mal mit ganz langsamer Drehzahl nochmal einen Versuch machen und evtl. den Schneidenwinkel (Spitzenwinkel) des Bohrers flacher anschleifen.
Der Zentrierbohrer hat ja 60° und dann kommt der Bohrer mit (denke 117° Spitzenwinkel) und geht punktförmig in die Zentrierung - er glüht an der Kante aus, wie eine Hand-Bügelsäge, die man unter Druck zu schnell über hartes Material jagt und die Zahnspitzen weichglüht.
Ich bin gespannt, wie das Problem hier noch gelöst werden kann.
Gruss Hansjörg
Materialprobleme ??
|
|
Nachrichten in diesem Thema |
Materialprobleme ?? - von Balu - 21.08.2012, 17:13
RE: Materialprobleme ?? - von Comaspahn - 21.08.2012, 21:30
RE: Materialprobleme ?? - von TassKaff - 21.08.2012, 23:32
RE: Materialprobleme ?? - von Balu - 22.08.2012, 00:28
RE: Materialprobleme ?? - von Comaspahn - 22.08.2012, 00:53
RE: Materialprobleme ?? - von Peppy66 - 22.08.2012, 04:16
RE: Materialprobleme ?? - von Schleibi - 22.08.2012, 08:04
RE: Materialprobleme ?? - von TassKaff - 22.08.2012, 14:29
RE: Materialprobleme ?? - von anulutk - 22.08.2012, 14:37
RE: Materialprobleme ?? - von HeGe - 22.08.2012, 15:09
RE: Materialprobleme ?? - von walter - 22.08.2012, 21:45
RE: Materialprobleme ?? - von Comaspahn - 23.08.2012, 00:09
RE: Materialprobleme ?? - von Balu - 23.08.2012, 00:41
RE: Materialprobleme ?? - von h_lauer - 25.08.2012, 21:48
RE: Materialprobleme ?? - von Eric - 17.09.2012, 19:18
RE: Materialprobleme ?? - von Kraftzahn - 09.10.2012, 11:57
RE: Materialprobleme ?? - von Schleibi - 10.10.2012, 07:48
RE: Materialprobleme ?? - von Posti - 09.10.2012, 21:11
RE: Materialprobleme ?? - von Kraftzahn - 10.10.2012, 07:55
RE: Materialprobleme ?? - von Posti - 10.10.2012, 19:13
RE: Materialprobleme ?? - von TassKaff - 10.10.2012, 22:07
|
Benutzer, die gerade dieses Thema anschauen: 9 Gast/Gäste