Hallo Bastelfans,
Ich hab da mal ´ne Frage….
Bei meiner Myford s7 Drehe bekomme ich beim Plandrehen keine rechtwinklige Fläche, sondern eine Erhebung. Das ist zwar schön anzusehen, wenn mein Drehteil sich auf der Planfläche wunderbar wie ein Kreisel dreht , für andere Anwendung aber nicht brauchbar.
Die Abweichung beträgt etwa 1/10mm auf einen Radius von 70mm (Mitte-Außen).
Hat jemand eine Idee, was ich außer dem Schlosskasten und Planschlitten noch einstellen muss?
v.G. Johannes
Planfläche schief
|
|
Nachrichten in diesem Thema |
Planfläche schief - von htm4 - 25.02.2010, 22:38
RE: Planfläche schief - von fritz-rs - 25.02.2010, 22:55
RE: Planfläche schief - von htm4 - 25.02.2010, 22:59
RE: Planfläche schief - von dlw - 25.02.2010, 23:00
RE: Planfläche schief - von Allemool - 25.02.2010, 23:01
RE: Planfläche schief - von htm4 - 25.02.2010, 23:15
RE: Planfläche schief - von buedes - 25.02.2010, 23:25
RE: Planfläche schief - von fritz-rs - 25.02.2010, 23:46
RE: Planfläche schief - von fritz-rs - 07.03.2010, 12:45
RE: Planfläche schief - von htm4 - 07.03.2010, 13:51
RE: Planfläche schief - von Lumpi - 07.03.2010, 14:21
|
Möglicherweise verwandte Themen… | |||||
Thema | Verfasser | Antworten | Ansichten | Letzter Beitrag | |
Fräse schief, bzw nicht einjustiert ? | walter | 14 | 12.926 |
14.04.2017, 19:53 Letzter Beitrag: schwarzfuss |
Benutzer, die gerade dieses Thema anschauen: 2 Gast/Gäste